New! Rust & hard water stain remover! Handle sold separately. Individually wrapped scrubbers mean no more dirty brush! All surfaces of the uniquely contoured scrubber clean under the rim. Entire scrubber contains pumice scrubbing foam. Made in Canada.
Contains anionic surfactants and pumice.
Clean & toss! 1. Tear open a fresh packet to reveal narrow end of scrubber with built-in cleaner. 2. Place handle tip into slot in scrubber. 3. Briefly dip scrubber in the water to get scrubber wet. Scrub stains at or above water line first (may take a few seconds to activate pumice scrubbing foam). Continue to scrub until stain disappears or foam diminished. If stain persists, see Note. 4. Hold handle with scrubber end over trash can. Use thumb to slide button forward until scrubber releases. Store handle. Do not flush scrubber. Note: If stain persists, repeat procedure with fresh Rust and Stain scrubber. (If stain persist below the waterline, try closing the water inlet valve, flush toilet to lower the water level and try to scrub again to remove stain. Reopen the valve). Will remove most rust and hard water stains. (Some delicate surfaces may scratch. Test in an inconspicuous area with pressure you desire to use. Not guaranteed to remove all stains.)